Taking Shape

June 16th found Slick framing up the wall that would close the room off from the living area. Some thought and discussion had to go into this step before he could proceed, as the original builder had (for whatever reason) interrupted the ceiling surface with a low beam. You can see it in the picture below. It runs along behind the top timber of the wall frame.

This beam didn't run in line with the wall of the room to the left. (Of course not, that would be too straightforward and logical.) Instead, it was set back a little more than the width of the wall. This meant that even though we set the wall frame on the outside of the beam (so the beam protruded into the bathroom) the new wall still wasn't quite flush with the old. This caused plastering challenges later on.

 

Inside the bathroom, after deciding on framing up the wall outside the beam, we were left with the problem of resolving the beam visually. It looked really odd, one wall jutting out at the top. We ended up figuring 'if you can't beat 'em, join 'em' and built look-alike boxes along the top of the other three walls. This transformed a problem into a stylistic distinction and advantage, saving us from the cornice issue and giving the bathroom an individual look and feel. However, it was painful to accomplish, as anyone versed in the art of plastering could inform you. The next picture will give you a glimpse of what it looked like in progress:

You can see that the box cornice surfaces consisted largely of plaster by the time we'd done two concave corners and one converse, with very little between. Blick learned to plaster on this room and she did a good job. (Those lights were the kitchen lights. We were a little short on light in the kitchen for a while!)

 

As you can see in most of the above photos, the bottom timber of the wall goes right from wall to wall. Eventually the door into the bathroom was to hang on the right-hand side, so after the wall had been built and secured Dad must have cut out the section of the base plate in the door area.

You may wonder about the pine two-by-fours. They are new, bought cheaply from the discard pile at our local building supply store. The timbers were too full of big knots and other weaknesses to be sold to construction builders who would use them in load or stress bearing situations. The timber was fine for our purposes as we were able to cut out the imperfections and use the timber in relatively low-stress applications. The walls, for instance, basically held up the gyprock, pine panelling and insulation. No major load bearing or lateral strain was being taken. Thus they were ideal for us.